Mixers

A “No Gain” Direct-Conversion IQ RF-to-Bits Receiver Without Active Linear Amplification

A “No Gain” Direct-Conversion IQ RF-to-Bits Receiver Without Active Linear Amplification 150 150

Abstract:

This work describes a direct-conversion IQ receiver (RX) that does not utilize any active linear (power) amplification, covering its design considerations, prototype implementation, and measurement verification. Only RLC components, MOS transistor (MOST) switches, and comparators are used, leading to several unique design challenges. Key among these are the fact that …

View on IEEE Xplore

A 1-8 GHz, 190MHz BB BW Mixer-First Receiver With Bootstrapped Mixer Switches Achieving Over 16dBm In-Band IIP3

A 1-8 GHz, 190MHz BB BW Mixer-First Receiver With Bootstrapped Mixer Switches Achieving Over 16dBm In-Band IIP3 150 150

Abstract:

In this article, we propose a wideband mixer-first receiver with improved in-band (IB) linearity. It uses bootstrapped N-path mixer switches to achieve a constant on-state gate–source voltage for large IB signals. We analyze the tradeoff between on-state resistance and off-state subthreshold current in conventional mixer switches and introduce a …

View on IEEE Xplore

A 160-Gb/s D-Band Bi-Directional CMOS Mixer Covering 112–170 GHz for 6G Transceivers

A 160-Gb/s D-Band Bi-Directional CMOS Mixer Covering 112–170 GHz for 6G Transceivers 150 150

Abstract:

This work presents a D-band bi-directional CMOS double-balanced mixer (DBM) supporting data rates over 160 Gb/s with a 58-GHz RF bandwidth (112–170 GHz). The mixer employs four identical NMOS passive switches ( $12~\mu $ m/60 nm) in a DBM topology, providing the isolation between RF, LO, and IF ports. Both IF and RF …

View on IEEE Xplore

A 240-GHz Sub-THz Direct-Conversion Transmitter With I/Q Phase Calibration in 40-nm CMOS

A 240-GHz Sub-THz Direct-Conversion Transmitter With I/Q Phase Calibration in 40-nm CMOS 150 150

Abstract:

A 240-GHz direct-conversion transmitter (TX), consisting of an LO chain and fundamental I/Q mixers, is proposed for sub-THz communication applications. The LO chain integrates phase-shifter-embedded impedance matching networks (IMNs) and frequency tripler with an optimized harmonic IMN, delivering I/Q LO signals at 240 GHz with high output power, 360° phase …

View on IEEE Xplore

A 10 to 40 GHz Reflection-Mode N-Path Filter

A 10 to 40 GHz Reflection-Mode N-Path Filter 150 150

Abstract:

A bandpass reflection-mode N-path filter (RMNF) with 2-GHz bandwidth and 10 to 40 GHz center-frequency tuning is presented. The design includes a broadband hybrid coupler, N-path reflectors, comprising four-phase passive mixers terminated with third-order in-phase and quadrature-phase active baseband loads, and a broadband clock-generation network. The reflectors realize an in-band open circuit …

View on IEEE Xplore

A Simultaneous Dual-Carrier Transformer-Coupled Passive Mixer-First Receiver Front-End Supporting Blocker Suppression

A Simultaneous Dual-Carrier Transformer-Coupled Passive Mixer-First Receiver Front-End Supporting Blocker Suppression 150 150

Abstract:

A high dynamic range N-path passive mixer-first receiver architecture capable of simultaneously down-converting two arbitrary bands through a single RF port is presented. The architecture consists of two passive mixers arranged in a series configuration with a transformer front-end to minimize cross-loading between mixers while still providing impedance transparency and …

View on IEEE Xplore

A Low-Power Blocker-Tolerant Wideband Receiver With Bias-Tunable Mixer and Effective Switch Resistance Compensation

A Low-Power Blocker-Tolerant Wideband Receiver With Bias-Tunable Mixer and Effective Switch Resistance Compensation 150 150

Abstract:

This article presents a mixer-first blocker-tolerant receiver (RX) with effective switch resistance ( ${R} _{\text {SW}}$ ) compensation and high-Q selectivity. By analyzing the impact of non-ideal 1/N LO duty cycle and effective ${R} _{\text {SW}}$ on mixer-first RX, an effective ${R} _{\text {SW}}$ compensation technique is proposed to mitigate noise figure (…

View on IEEE Xplore

A Capacitive Stacking Mixer-First Receiver With Higher Order Capacitive Feedback

A Capacitive Stacking Mixer-First Receiver With Higher Order Capacitive Feedback 150 150

Abstract:

This article presents a capacitive stacking mixer-first receiver (MF-RX) with a higher order capacitive feedback (CFB) loop designed to increase interferer rejection right at the mixer baseband (BB) node, benefiting both the out-of-band (OOB) linearity of the passive mixer switches and the active BB circuitry. The CFB loop consists of …

View on IEEE Xplore